1. Number of packages are needed to run myCNC sofware on Cubieboard2.
To install it run -
sudo apt-get update
sudo apt-get install ffmpeg libsdl1.2debian libopencv-dev libusb-1.0
2. Download myCNC-arm-linux last distribution file from download page.
3. Run the file with administrator rights:
4. Press Y <Enter> to confirm you like to install myCNC software.
5. Press Y <Enter> to accept EULA terms.
6. Enter myCNC destination folder ("myCNC" by default). The software will be installed on "/opt/YOUR_FOLDER"
7. Installation will be finished in a few seconds.
8. To run the myCNC software use script file myCNC.sh in myCNC folder.